Adjustment - Kidwell ZOOCAR Benutzerhandbuch

HANDLEBAR DISASSEMBLY
2
To remove the handlebar, simultaneously press both handlebar lock push buttons (Fig. 2.1)
and pull the handlebar from its opening.

ADJUSTMENT

3
To change the handlebar height, turn the handlebar height adjustment clamp (Fig. 3.1.).
Then push the locking pin (Fig. 3.2), so that it does not protrude beyond the handlebar,
and adjust the handlebar height to one of the three available levels, until the locking pin
bounces and appears in the opening on the handlebar side. To prevent the handlebar
from moving, tighten the handlebar height adjustment clamp.
NOTE: After selecting a suitable handlebar height for your child, make sure that the
locking pin protrudes from the handlebar, which means that the handlebar height lock
is correctly positioned, and that the adjustment clamp is tightened fully and adjacent to
the handlebar.
STEERING
4
To turn the scooter, turn the handlebar to the right or left.
NOTE: The handlebar should not rotate.
BRAKING
5
The rear wheel mudguard also acts as a brake. To start braking, step on the mudguard.
NOTE: If you step on the brake with your entire body weight while the scooter is moving
fast, it may cause a sudden stop, loss of balance and injury.
10