ECTIVE BM 50 Bedienungsanleitung Seite 23

ECTIVE BM 21
to be reset In the main menu, press and hold the button for
three seconds to set the „zero" capacity value (be sure to fully
discharge the connected battery first) Press and hold the
button for three seconds to set the „100%" capacity value
(be sure to fully charge the connected battery first) Note: These
actions cannot be undone
Using the battery monitor when in standby mode
1 When the battery voltage is lower than the turn-off voltage
value, the battery monitor will enter a low-power standby mode
When you need to check the battery's capacity, simply press
any button to activate the display for ten seconds After the ten
seconds, if the battery voltage is still below the turn-off value,
the battery monitor will re-enter standby mode If at any time
the battery voltage rises over the turn-off value - or the battery
starts charging or discharging - the battery monitor will exit
standby mode and resume normal operation
2 If the battery has a high capacity and the turn-off voltage has
been set correctly, the battery monitor can remain connected to
the battery without an additional switch for a long time
batterium GmbH
Robert-Bosch-Straße 1, 71691 Freiberg am Neckar, Germany
T: +49 7141 1410870 | F: +49 7141 1410875
info@ective de | ective de
© batterium GmbH, Edition 2, 03/2022