Care And Cleaning; Cleaning The Grease Filter - Electrolux LFP716W Benutzerinformation

The function is activated if two white LED
indicators flashes for 3 seconds. The
function is deactivated if only one LED
indicator flashes for 3 seconds.
To reset the function counter out of
notification period:
1. Pull out the hood drawer.
2. Make sure that the fan is turned off.

4. CARE AND CLEANING

4.1 Notes on cleaning
Cleaning
Agents
Keep the hood
clean
Charcoal filter

4.2 Cleaning the grease filter

Filters are mounted with the use of clips
and pins on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip
on the filter panel underneath the
hood.
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water
and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains
appliance must be cooled down and dried with clean cloth or paper
towels.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the inte‐
rior and grease filters carefully from fat. Fat accumulation or other
residue may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cy‐
cle. The grease filter may discolour, it has no influence on the per‐
formance of the appliance.
The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter.
3. For grease filter press
seconds.
4. For charcoal filter press
seconds.
The indicator blinks once for correct
reset.
1
2
2. Slightly tilt the front of the filter
downwards, then pull.
Repeat the first two steps for all filters.
ENGLISH 33
for 3
for 3