Cleaning The Grease Filter; Replacing The Lamp; Environmental Concerns - Zanussi ZHB92670XA Benutzerinformation

CLEANING THE GREASE FILTER

Filters are mounted with the use of clips and pins
on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip on the
filter panel underneath the hood (1).
1
2
2. Slightly tilt the front of the filter downwards (2),
then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first two
steps in reverse order.
Repeat the steps for all filters if applicable.

ENVIRONMENTAL CONCERNS

Recycle materials with the symbol
packaging in relevant containers to recycle it. Help
protect the environment and human health by
recycling waste of electrical and electronic
appliances. Do not dispose of appliances marked
REPLACING THE CHARCOAL FILTER
To replace the filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.
2. Press the front edge in slot towards the bottom
3. To install a new filter, perform the same steps in
In any case, it is necessary to replace the filters at
least every four months.

REPLACING THE LAMP

This appliance is supplied with a LED lamp and
separate control gear (LED driver). These parts can
be replaced by a technician only. In case of any
malfunction refer to "Service" in the "Safety
Instructions" chapter.
with the symbol
. Put the
Return the product to your local recycling facility or
contact your municipal office.
WARNING! The charcoal filter is non-
washable!
part of the filter. Slightly tilt the front of the filter
downwards.
reverse order.
with the household waste.
21