Barracuda Secure Connector Kurzanleitung Seite 5

2
Power
A
Power via Power over Ethernet
• Connect the WAN port to a PoE compatible device. The Secure Connector
powers on automatically.
• Verify that power LED on the front of the Secure Connector is on.
B
Power via Power Supply Unit
• Make sure pin connector is installed correctly.
• Plug in pin connector to appliance 12Vdc.
• Plug in power cord of power supply to outlet. The Secure Connector powers
on automatically.
• Verify that the power LED on the front of the Secure Connector is on.
3
Connect
• Connect the USB cable to the Secure Connector OTG port.
• Connect the other end of the USB cable to your PC.
• The Secure Connector is mounted as mass storage device on your PC. This can
take up to two minutes.
Secure Connector's OTG port
Management PC
Setup 2