Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fitting the side wheels (if available)
1.
Loosen the rear axle bolts and remove the fender stay.
2.
Fit the support wheel arm on the rear axle against the locking plate which is
already fitted on the rear axle). Make sure the rear wheel does not slide in the
frame.
3.
Screw the outer axle nut tight when the desired height of the side wheels has
been found. The side wheels should stay about 6 mm above the ground on
both sides.
Handlebar pad
Use these cushions by attaching them to the handlebars and stem with the Velcro
strap.
The hand brake
The hand brake is already mounted on the bike. Check whether the brake blocks
press firmly on the rim when braking. Adjust them if necessary and do this regular-
ly:
1.
If the margin in the brake handle is too large, tighten the brake cable nut at
the handle to make it tighter.
2.
Double check to see if the brake pads are pressing firmly against the rim
when you squeeze the handbrake. If the pads do not fit properly on the rim or
if they are crooked, you can unscrew the inner cable nut.
3.
Next, straighten the brake pads with one hand. With the other hand, pull on
the inner cable and tighten the inner cable nut again.
4.
You can adjust the distance between the brake blocks and rim by turning the
adjusting screw clockwise if further adjustment of the brakes is needed. Make
sure that the brake cable is firmly connected to the brake cable nut when
adjusting.
5.
Lastly, tighten the lock nut securely.
Still having trouble? Ask an expert to help you. Brakes are an essential part of the
bicycle.
Checking the back pedal brake
It is a useful exercise to check whether the rear wheel turns smoothly before using
the bike. If the wheel turns stiff, this is usually due to the back-pedal brake being
tightened too much. The back-pedal brake is located at the rear wheel axle on the
left-hand side and can be corrected in the following way:
1.
Unscrew the bolt from the joint.
2.
Rotate the joint back in anticlockwise direction (one rotation should be suffi-
cient).
3.
Tighten the bolt of the joint.
Assemble basket and doll seat (if equipped)
1.
Attach the basket to the front, using the 2 supplied bolts and nuts.
2.
Attach the doll's seat to the back, by sliding it onto the doll's seat mounting
arm. Secure the seat using the 2 screws supplied.
3
Werbung
