Operating Your Freezer - Frigelux CCO100BES Benutzerhandbuch

Installing Your Freezer

This appliance is designed to be free standing only, and should not be recessed or
built-in.

Place your freezer on a floor that is strong enough to support the freezer when it is
fully loaded.

Allow 9 cm of space between the back and 20cm between sides of the freezer, which
allows the proper air ventilation. Adjust the feet to keep the freezer level.

Locate the freezer away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also cause
the freezer not to perform properly. This unit is not designed for use in a garage or
any other outside installation.
 Avoid locating the freezer in moist areas.
 Plug the freezer into dedicated, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized service center. This unit is not designed to be installed in
an RV or used with an inverter.
 After plugging the appliance into a wall outlet, turn the unit on and allow the unit to
cool down for 2~3 hours under before placing food in the freezer compartment.
Make sure that sufficient room is provided around the appliance to ensure free air circulation.

4. OPERATING YOUR FREEZER

Temperature Control
Appliance thermostat has 7 settings. The appliance assures that temperature is maintained
as long as it is in operation and that it is used in normal conditions of use. The temperature
inside the appliance can be influenced by many factors : ambient temperature, sun exposure,
number of door opening and amount of food stored... The slight changes in temperature are
perfectly normal.
22