Charging The Device; Maintenance And Cleaning - Zelmer ZGK6300 Benutzerhandbuch

AF-MANUAL SET DE ARREGLO ZELMER ZGK6300.pdf
rotate the groomer.
IMPORTANT: Avoid inserting the cutting unit more than 6mm into your nostril.

CHARGING THE DEVICE

Before using your groomer for the first time, charge for 2-3 hours, and charge 2
hours regularly. Ensure the product is switched off. The hair trimmer is complete-
ly handy to carry and can be charged anywhere with the USB cable (Fig.12). First
insert the plug on the end of the USB charging cable lead into the unit and then
connect the USB charging cable to the USB interface. This appliance is suitable
for 5V DC Max 1A charger, computer and other power interface, the charging
indicator is red when the battery is charging connecting the USB interface, the
C
charging indicator is green when the battery is full. IMPORTANT: This product is
M
for cord and cordless use. Your groomer cannot be overcharged. However, if the
product is not going to be used for an extended period time (2-3 months), unplug
Y
it from the mains and store. Fully recharge your hair clipper when you like to use
CM
it again. To preserve the life of your batteries, let them run out every 2 months
MY
then recharge for 2-3 hours again.
CY

MAINTENANCE AND CLEANING

CMY
Unplug the product when you do not intend to use it for an extended period of
K
time to prolong its shelf-life. Allow the device to cool down prior to storage.
Separate the tool head from the body and use the cleaning brush (Fig.5) to
remove dust from the internal parts. Apply a drop of oil (Fig.11) on one of the
edges of the blades for their maintenance, and turn on the device for a few
seconds to distribute it. This should be done when you notice a certain amount of
difficulty during the trimming operation.
Ensure that the device is unplugged prior to cleaning it.
This device may only be cleaned with a damp cloth, and chemical products must
never be used for the same.
14 22/6/21 16:25
EN