BRAX GX2400 Bedienungsanleitung Seite 21

The control range extends from 1.0 V (maximum CW) to 8.0 V (maximum CCW).
10 - 11 Operation mode switch
MONO BRIDGED
STEREO BRIDGED
10 11
STEREO
CHANNEL A/B
To select the mode of the amplifier. This switches are located on the bottom of the amplifier.
Stereo: Select the STEREO MODE for using the channels A/B or C/D in a 2-channel mode. In this configuration all four
level controls are activated to adjust the input sensitivity.
Stereo Bridged: Select the stereo bridged mode for using the channels A/B or C/D in the mono mode. In this configuration
both channels are bridged to one channel (mono). At position STEREO BRIDGED both signal inputs of the channels
A/B or C/D have to be used. In this configuration all four level controls are activated to adjust the input sensitivity. Both
controls of the bridged channel pair should be set to the same position.
Mono Bridged: Similar as in mode stereo bridged the amplifier is switched to mono and both channels will be bridged to
one channel. If you select MONO BRIDGED only the input A or C has to be used. This can be necessary if there is
only one mono signal available. In this configuration only one level control A or C is activated to adjust the input sensitivity
of the bridged channel pair.
10
MONO BRIDGED
STEREO BRIDGED
STEREO
CHANNEL C/D
Operation mode switch for channels A/B
Operation mode switch for channels C/D
11
21