Carpoint 0177715 Benutzerhandbuch Seite 4

If indicator light is green, turn rotary switch to the "ON" position and start your vehicle, if indicator light is red reverse clamp connections
before proceeding. Once vehicle starts, turn rotary switch to "OFF" position and disconnect black clamp first and then, red clamp. Restore
cables on jumpstarter and recharge unit at first opportunity.
NOTE: WHEN STARTING VEHICLE, CRANK ENGINE IN 5-6 SECOND BURSTS. IF VEHICLE DOES NOT START UP WITHIN
2-3 ATTEMPTS, ALLOW THE JUMPSTART TO COOL FOR 3 MINUTES BEFORE ATTEMPTING TO START VEHICLE AGAIN.
RETRY ONLY IF BATTERY CONDITION IS SATISFACTORY.
WarnIngs:
• Do not turn cable safety switch to "ON" position if indicator light is red. Turn "ON" only when light is green.
• Do not allow the positive and negative booster clamps of the jumpstarter to contact each other (or a common piece of metal) at any time.
Sparking, an explosion, or damage to the unit may result.
• When jumpstarting a vehicle, make sure that the positive and negative booster clamps are properly connected to the vehicle and battery.
Failure to connect the clamps properly may cause sparking, and explosion or damage to the unit.
• Always wear eye protection when working with batteries.
• If battery acid comes into contact with eyes, flush the eyes with water for at least 10 minutes. Go to a doctor immediately.
• If skin or clothing comes into contact with battery acid, immediately wash the affected area with soap and water. Go to a doctor if
redness, pain or irritation occurs.
• Be sure to remove all metal items (watches, necklaces, rings, etc.) before using the jumpstarter.
• Always turn the jumpstarter off when not in use. Store in a cool, dry place.
• Do not open the jumpstarter. There are no user serviceable parts in this unit. Doing so will void the warranty.
OPERATING WORKLIGHT
The jumpstarter comes with a built-in worklight. The light is directly connected to the jumpstarter's internal battery. Light will operate for up
to 40 hours from a fully charged battery. Turn off light when no required to conserve battery power.
Replacement bulb: The bulb in this unit is 12V 3 watt, designed to provide many hours of operation. In the unlikely event that this should
burn out or require replacement, bulbs can be obtained at our local electrical supply outlet. To replace bulb, remove lens by unscrewing
screw. Gently remove bulb. Replace bulb and reassemble light.
USE AS A 12 VOLT DC PORTABLE POWER SUPPLY
The jumpstarter is equipped with an outlet socket and can be used to operate most 12V car accessories and appliances (11A maximum)
equipped with a cigarette lighter plug. Simply lift up cover on socket and plug in appliance. Place power outlet switch located above socket
in the "ON" position. Length of time appliance will operate is depended on the condition of battery and current draw of appliance.
Periodically check battery status during operation and discontinue use immediately if battery condition falls to red level. Recharge unit as
soon as possible and before further use.
Power outlet is protected by an internal circuit breaker to prevent damage to unit in case appliance has a short circuit or exceeds 11A. If
circuit breaker is tripped, disconnect appliance and have it checked. Circuit breaker will automatically reset once it cools down (approx.
15-20 minutes).
DO NOT PLUG A CIGARETTE LIGHTER INTO THE OUTLET OF THE JUMPSTARTER.
BATTERY
The unit is equipped with a 12V 17Ah maintenance free, sealed lead acid rechargeable battery, which has a normal life expectancy of up to
500 charging cycles and will give many years of dependable service if properly cared for following the directions above. In the event that
the battery needs replacement in the future, the unit will have to be opened up by loosening the screws holding the housing together.
Carefully lift off back housing to gain access to the battery. Replace and reassemble.
Replacement batteries may be purchased from an electrical supply store. Old battery should be disposed of properly and safely. Some states
required recycling. Please contact your local solid waste authority for recycling information.