Carpoint 0177715 Benutzerhandbuch Seite 2

JuMPstarter
WelcoMe
This product has been carefully engineered and manufactured to give you a reliable operation. Please read this manual carefully before
operating your new product, as it contains information you need to become familiar with its features. Please keep this manual on file for
future reference.
11
controls
1. Reverse battery polarity LED indicator
2. 12 Volt Power outlet ON/OFF switch
3. 12 Volt Power outlet
4. Battery check button
5. Charge level indicator LED
6. Charging indicator light
7. Input charging socket
8. Work light ON/OFF switch
9. Work light
10. Positive (Red) and Negative (Black) booster clamps
11. AC charger
12. DC charging cord
13. Safety Switch – the rotary switch on the left hand side of the unit controls the power to the booster cables. ALWAYS leave this in the "OFF"
position except when jump starting a vehicle.
CHARGING THE JUMPSTART SYSTEM
This unit has a maintenance free built in sealed lead acid battery. Although the jumpstart system arrives partially charged from the factory, it
MUST BE FULLY CHARGED FOR 38 HOURS BEFORE FIRST USE, even if the battery status lights indicate a "full" charge. This initial charge pre-
conditions the battery. Failure to follow this procedure may permanently damage the battery.
cHargIng WItH tHe ac PoWer adaPtor
Plug the AC adaptor into any 230 volt AC wall outlet and the other end into the input socket of the jumpstart system. The charging indicator
light will illuminate to indicate the unit is charging. Full charging will take approximately 34-36 hours (depending upon power used).
cHargIng WItH tHe dc PoWer cord
Plug the DC power cord into your vehicle's cigarette lighter socket and the other end into the input socket of the jumpstarter. Full charging will
take approximately 14-16 hours (depending upon power used).
2
13
3
4
1
12
9
5
8
10
6 7