Maintenance Of The Welding Helmet; Technical Specifica�Ons - SOLDATECH EWH980 Montage- Und Bedienungsanleitung

Maintenance of the welding helmet

Replace the protec�ve plates in case they are damaged or broken.
8. Remove the outer protec�ve plate by li�ing it in the middle with a finger and sliding the
plate out of the guide.
9. Clean the filter carefully with a so� �ssue or clean so� co�on cloth. Never use water, other
fluid, oil-based detergents or corrosive fluids.
10. Place back the protec�ve plate.
11. Check if the protec�ve plate is placed back correctly in the guide.
12. Repeat steps 1 to 4 for the inside.
13. Clean the welding helmet with a damp cloth, only use water or neutral cleaners, during
cleaning make sure the protec�ve plates don't get wet.
14. Never remove the filter out of the welding helmet.
5. Technical speci cations
Op�cal class according to EN379
Viewing area
Cartridge size
Arc sensor
UV/IR protec�on
Light state
Dark state
Shade control
Power on/off
Sensi�vity control
UV/IR protec�on
Power supply
Switching �me
Dark to light
Low amperage TIG
1/1/1/2
98 x 80mm
133 x 114 x 10 mm
4
Upto shade DIN 16
Shade DIN 4
Variable 9-13
Solar cell, CR2450 Lithium ba�ery
Fully automa�c
Low – high infinitely dial knob
Grinding, TIG welding, MIG CO2 welding, ARC
electric welding, plasma cu�ng, tes�unc�on
Light dark 1/25000 sec
Dark light 0,1 ~ 1 sec
≥ amps (AC) ≥ amps (DC)
-5°C ~ 55°C
-20°C t/m 70°C
13