Herunterladen Inhalt Inhalt Diese Seite drucken

Adjus�Ng The Delay Se�Ngs; Adjus�Ng The Fit - SOLDATECH EWH980 Montage- Und Bedienungsanleitung

Automatisches schweißhelm
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Adjusting the delay settings
The delay �me is the �me which the helmet needs to switch from fully dark to fully light, depending
on the welding current and the welding length. The delay can be adjusted with bu�on 2 (fig.1), the
recommended se�ngs are as follows:
1. Set to MIN (0,1s-0,25s) for spot welding, short welds or when welding seams.
2. Set to MAX (0,85s-1s) for welding with high amperage and to prevent exhaus�on of the eyes
during ARC welding.
3. The middle range is suited for most welding both indoors and outdoors.
Adjusting the t
Besides se�ng the correct values for the se�ngs above,
adjus�ng the fit is also very important. It can be adjusted as
follows:
1. With belt 1 (fig.3) U can set how far the helmet goes
over your head. Let the helmet go as low as possible in
order to also protect the neck sufficiently.
2. With adjustment knob 2 (fig.3) you can set the
�ghtness of the headband, this should be �ght, but not
so �ght that it causes suffer.
3. With adjustment knob 3 (fig.3) you can set how easily
the mask can move up and down.
Fig. 3
11

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für SOLDATECH EWH980

Inhaltsverzeichnis