Installing The Batteries To The Remote; Connect Power & Antenna/Cable; Switching On/Off; First Time Installation - Finlux 42FLSY170LHD Bedienungsanleitung

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Switching On/Off

To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control or press the "
To Switch the TV Off
Press the " " button on the remote control or press
the " " button on the TV. The TV will now switch to
standby mode.
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, the standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.
" button on the TV.
English - 41 -

First Time Installation

When turned on for the irst time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the " " or "
required language, press OK button to select. "First
Time Installation" appears. Use "
to set the required country, and press "
to select Search Type. Use "
desired search type. Available search types are Digital
and analog, digital only and analog only. When set,
press " " to select Teletext Language. Use "
" " button to set the "Teletext Language" and select
"Scan Encrypted" using "
can set Scan Encrypted as Yes if you want to scan
coded stations.
Default PIN code can change depending on the
selected country. If you are asked to enter a PIN code
for viewing a menu option, use one of the following
codes: 4725, 0000 or 1234.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
" button to highlight the
" or " " button
" button
" or " " to set the
" or " " button. You
" or