Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY! DO NOT USE HOT WATER IN THIS
Starting Up
After connecting the pressure cleaner to your cold water supply, proceed as follows:
-
Make sure that the ON/OFF switch is in the OFF position.
-
Connect the garden hose to the inlet fitting.
-
Attach the hose to the gun as per assembly instruction step #1.
-
Screw the washer handle tight to the main body as per assemble instruction step #2.
-
Install gun hook and power cord hook, screw the gun holder as per assemble instruction step #3
-
Insert the adjustable spray nozzle into the gun as per assembly step #4.
-
Connect the high pressure hose to the high pressure outlet fitting as per assembly step #5.
-
Connect the garden hose to the high pressure washer inlet fitting as per assembly step#6.
-
Open the water supply valve completely.
-
Before turning the unit on, press the gun trigger to bleed all the remaining air out of the pump and
hose.
-
Start the pressure cleaner by turning the on/off switch to the on position and squeeze the trigger.
REMINDER: Motor does not run continuously, only when the trigger is squeezed.
WARNING – RISK OF INJECTION! Unit will start spraying when trigger is squeezed.
When turning the unit off after use, high pressure still exists inside the hose and unit.
Point the gun in a safe direction and discharge the excess pressure. NEVER direct the
high pressure water stream at people or animals.

Automatic On/Off

The pressure cleaner is equipped with an automatic on/off switch. The pressure cleaner will only run when
the power switch is in the ON position and the trigger on the gun is squeezed. When you release the trigger
to stop spraying water through the gun, the motor on the pressure cleaner will automatically shut off. Simply
squeeze the trigger again to resume using the cleaner. To stop using the pressure cleaner, release the
trigger and switch the unit to the OFF position. The unit should be turned completely OFF while not in use or
while unattended.
OPERATING INSTRUCTIONS
PRESSURE CLEANER!
22/42

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis