Automatic On/Off - MALTEC M2.1400 Bedienungsanleitung

Automatic On/Off

The pressure cleaner is equipped with an automatic on/off switch. The pressure cleaner will only run when
the power switch is in the ON position and the trigger on the gun is squeezed. When you release the trigger
to stop spraying water through the gun, the motor on the pressure cleaner will automatically shut off. Simply
squeeze the trigger again to resume using the cleaner. To stop using the pressure cleaner, release the
trigger and switch the unit to the OFF position. The unit should be turned completely OFF while not in use or
while unattended.
Bleeding The Gun
It is very important to bleed the gun before using the pressure cleaner. Refer to the "Assembly Instructions"
to assemble the pressure cleaner. To bleed the gun, simply connect the garden hose to the pressure cleaner
and squeeze the trigger BEFORE turning the electrical supply on. This allows any air trapped inside the
pressure cleaner and gun to be removed before using the unit. Continue holding trigger for approximately
one minute to allow any excess air out of the unit. Water will flow through the gun at low pressure during this
procedure. For more bleeding tips, see the section titled "Operating Instructions."
Gun Safety Lock
This pressure cleaner is equipped with a gun trigger safety lock. When not using the pressure cleaner, use
the safety lock to keep from accidentally engaging the high pressure spray.
Adjustable Spray Nozzle
The adjustable nozzle will allow you to use any variety of spray patterns from a full fan spray (diagram 1) to a
direct stream spray (diagram 2). When using the pressure cleaner to clean wood decks, siding, vehicles etc.,
always start using the fan spray and begin spraying from a minimum 36" away to avoid damaging the surface
of the material you are cleaning. Always begin by spraying in a testing area free and clear of people and
objects.
24/45