Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2 HELITEST START UP
Switch on HeliTest by pressing the ON pushbutton; fig.
3-4 shows the display:
-
-
-
- H e
l
i
T e s
W e
l
c o m e
Figure 3-4
NOTE
If the language is not the desired one, please refer to
paragraph 3-1 to change it.
3.2.1 Self test
After about 4 seconds from ON, HeliTest automatically
starts a self test routine procedure; the display will
appear as shown in fig. 3-5:
S e
l
f
t
p
r
o c e d u
Figure 3-5
NOTE
During test and operation, an asterisk, at the bottom
right end of the display, will blink.
No action is required by the operator until the self test
routine is finished or a fault occurs.
All manuals and user guides at all-guides.com
t
-
-
-
-
*
e s
t
r
e
*
16
CHAPTER 3 - OPERATING INSTRUCTIONS
After about 4 seconds, the message shown in
fig. 3-6 will appear:
H e a
t
e
r
Figure 3-6
At the end of the heater test (about 4 seconds), if the
test is successful, the following message is shown:
H e a
t
e
r
O K
Figure 3-7
or, if the test is negative and the heater is defective,
the following message is shown:
H e a
t
D E F E C T
Figure 3-8
NOTE
When this message is displayed, the self test routine is
stopped. This message is displayed for 1 minute, then
HeliTest is automatically switched off.
Repeat the self test routine following paragraph 3.2.
If the heater is still reported "DEFECTIVE", contact the
sales office.
Subsequently, the battery is tested and the display
shown in fig. 3-9 will appear:
B a
t
t
e
r
y
Figure 3-9
At the end of this test, if the battery voltage is greater
than 11.2 Vdc, the following message is shown:
B a
t
t
e
r
y
O K
Figure 3-10
t
e s
t
*
t
e s
t
*
e
r
I
V E
t
e s
t
*
t
e s
t
*
87-900-045-01 (D)
Werbung
Inhaltsverzeichnis
