velopa Easylift Premium Montageanleitung Seite 14

MI-98909010
10a
Attention:
- The angle of the consoles after mounting are 2 degrees biased upwards (as shown).
- See 10b below for adjusting consoles with shim washers if required.
( )
10b
If adjusting angle with shim washers is required:
- Loosen 4x console bolts
- Remove 2x front bolts
- Install shim washers between console and cross-beam (as shown)
- Reinstall front bolts
- Tighten all console bolts
- Check angle of console is per 10a or that tray stays down when deployed (add or remove shim washers as needed).
© Copyright VelopA B.V.: All rights reserved, Art. 31 and seq. of the Copyright Act.
This document remains property of VelopA B.V. and may not be revealed to third parties,
duplicated or used for any application, without explicit permission of the owner.
Mounting instruction Easylift Premium
Console low
Shim
Washers
Art.no. various
!
!
bvdwerf
11-09-2017 Rev. 04
www.velopa.com
14/19
+0,2°
2°
0°
+0,2°
2°
0°
© Copyright VelopA B.V.: Alle rechten voorbehouden, Art. 31 e.v. van de auteurswet.
Dit document blijft eigendom van VelopA B.V. en mag niet aan derden ter inzage worden gegeven,
gedupliceerd of voor uitvoering worden gebruikt, zonder uitdrukkelijke toestemming van de eigenaar.
!
Console high
Shim
Washers