Settings (Only By Trained Specialists); Standard Settings - CSS BIF8plus Gebrauchsanweisung

9. Settings (only by trained specialists)

The housing may only be opened by trained specialists!

Standard settings:

Usually the 3 IR remote control is supplied fully assembled and equipped ex
works. This means that no further changes need to be made to the hardware
at this point. If there are several (up to 4) bed controls in one room, it must be
ensured that each remote control controls its own bed. For this, the addresses
of the respective
Change the adress of the remote control
3
•
Press and
• Change BIF8plus adress with the
Press and
Address/button 1 is used as the default address in the factory settings.
Individual settings with BIF software:
Connect BIF8plus to power supply
1
•
Supply the
BIF8plus
• Connect BIF8plus to PC
Connect the
BIF8plus
• Start software
Then start the Universal Configurator software.
• Assign functions
Now you can assign the functions to the appropriate relays by clicking on
them. Confirm your final entry with
3
IR remote controls and
with the appropriate adress (red number).
again and confirm with
with power
to the PC via USB.
Instructions for Use
must be set:
BIF8plus
IR remote control
3
.
.
(220V)
Set.
1
| 21
BIF8plus
EN