Fcc Compliance Statement - Bellman & Symfon BE1470 Bedienungsanleitung

FCC compliance statement

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular in-
stallation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the follow-
ing measures:
• Reorient or relocate the receiving antenna.
113 Installer's guide
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
This equipment complies with FCC/IC radiation exposure
limits set forth for uncontrolled equipment and meets FCC
radio frequency (RF) Exposure Guidelines and RSS-102 of
the IC radio frequency (RF) Exposure rules. This equipment
should be installed and operated with at least 20cm and
more between the radiator and person's body (excluding
extremities: hands, wrists, feet and ankles).
Industry Canada statement
Le fonctionnement de cet équipement est soumis aux
conditions suivantes:
(1) l'équipement concerné ne doit pas causer d'interférences,
et (2) il doit accepter toute interférence reçue, y compris
les interférences risquant d'engendrer un fonctionnement
indésirable. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
This Class B digital aparatus complies with the Canadian
ICES-003.
Installer's guide 114