The luminaire is only to be connected to an alternating current – with the voltage according to the rating plate – to a
properly installed safety socket. Please note that your system corresponds to the relevant VDE guidelines.
If you have any questions about this, please contact your energy supplier or your electrician.
Of course we are at your disposal if you have any questions.
ATTENTION!
In the case of versions of the luminaire with other plug-in systems (not Schuko®), the voltage according to the rating
plate must be observed.
WARNING!
• Lay the cables in such a way that there are no tripping hazards and they are protected from mechanical damage
such as tearing off or being run over.
• If necessary, secure the cables with tape or cable ties.
• Make sure the luminaire is securely set up and fastened before use.
• Also observe the applicable regulations on occupational safety!
Electrical connection
Connect the mains plug of the connecting cable to your mains connection socket.
The luminaire is ready for operation once it has been connected to the mains power supply.
Fault
LED without function
Partial failure of the LEDs
WARNING! Electric current!
Before any maintenance, cleaning and care, the device must always be disconnected from the power supply by pulling the
mains plug.
Do not use any solvents, alcohol or other chemicals to clean the plastic parts / metal parts.
To remove dirt, dust, oil and grease, etc., use a soft, dry, lint-free cloth.
The ALDEBARAN® HI-LINE LED luminaire was designed to be maintenance-free. Therefore no maintenance work is
necessary. The product is repairable. If necessary, individual components can be replaced or repaired by a specialist.
Initial operation
Fault
Possible cause
Disconnection from the supply
network
Defective LED
Cleaning and care
Maintenance and repair
Solution
Check the connection to the power
supply
Repair necessary
11