Concept PERFECT SKIN PRO IL5020 Bedienungsanleitung Seite 65

EN
• Do not use the appliance to remove eyelashes, eyebrows or head hair.
• The appliance is not suitable for full removal of male beard.
• For your comfort and safety, we recommend asking someone to help you with the first
few treatment sessions.
• Use the PRECISION mode to remove facial hair. DO NOT USE THE GLISS MODE TO TREAT
FACE OR SENSITIVE AREAS.
• When treating your face, it is necessary to wait 5 seconds between each pulse. The
duration of the facial skin treatment session should not exceed 10 minutes.
DURATION OF ONE TREATMENT SESSION
Area Average duration
Half of a leg 8 to 10 minutes
Whole leg 15 minutes
Bikini line 2 minutes
Armpits 1 minute
SELECTING THE INTENSITY LEVEL
The intensity level designates the power of the pulsed light applied to your skin during
treatment. The power ranges from the lowest (1) to the highest (5) level.
The light indicator indicates the selected intensity level. If you increase the power, the
results will be better, but the risk of side effects increases (see chapter Possible side effects).
Warning: If you do not experience any abnormal reactions or discomfort within 48 hours
of the test treatment, you can select the power level of the epilator for the first treatment
according to the table below:
• Skin phototype I and II - For the first treatment, set the appliance to a maximum of the
3 rd intensity level. If you do not experience any problems, you can gradually increase the
intensity to level 4 and then to level 5 over the next few treatments.
• Skin phototype III and IV - For the first treatment, set the appliance to a maximum of the
2 intensity level. If you do not experience any problems, you can gradually increase the
nd
intensity to level 3 and then to level 4 over the next few treatments.
• Skin phototype V - For the first treatment, set the appliance to a maximum of the 1
128
Mode
Gliss
Gliss
Precision
Precision
st
IL5020
intensity level. If you do not experience any problems, you can gradually increase the
intensity to level 2 and then to level 3 over the next few treatments.
• The IPL epilator is not suitable for people with skin phototype VI.
Warning: Before using the appliance, read the entire instruction manual and select a safe
power level (see the phototype table below) for each treatment.
To ensure safe use of the appliance, the above-mentioned intensity selection guide must be
used together with the table below.
Phototypes (according to Fitzpatrick)
I Very pale, milky skin - never tans and always burns
II Fair skin - tans minimally and usually burns
III Beige skin - develops a light tan, occasionally burns
IV Light brown skin - tans easily and burns minimally
V Dark brown skin - tans very easily and rarely burns
VI Black skin
PHOTOTYPES I II
TEST TREATMENT
(carried out 48 hours
Level 1 Level 1
before the first
treatment)
First treatment Level 3 Level 3
Following treatment Levels 4, 5 Levels 4, 5
X - The appliance is not suitable for people with skin phototype VI.
It is possible that the required intensity level will vary depending on the difference in skin
colour of one area of the skin to be treated. For example, the skin on the hands, which is
usually exposed to the sun more often, is darker than the inside of the arm. Be careful when
increasing the intensity on paler parts of the body. Although you will achieve better results,
the risk of side effects increases.
IL5020
EN
III IV V VI
Level 1 Level 1 Level 1 X
Level 2 Level 2 Level 1 X
Levels 3, 4 Levels 3, 4 Levels 2, 3 X
129