Connect Satellite Antenna; Connect Tv Set; Connect Power Supply; Insert Batteries Of Remote Control - Avanit SHD5 Schnellstartanleitung

Table of Contents

1.2 Connect Satellite Antenna

 Connect the antenna cable to the receiver connection LNB IN.
Further receivers can be connected at the connection LNB OUT. The signal is
looped through from input LNB IN.

1.3 Connect TV Set

As stated in the connection scheme, the AVANIT SHD5 offers two possibilities to
connect TV set and receiver. The possibilities applicable to you depend on the con-
nection possibilities of your TV set.
The TV set provides of an HDMI connec-
tion:
 Connect TV set and receiver by using an
HDMI cable.


1.4 Connect Power Supply

 When all devices are properly connected to the receiver you can connect the
mains plug to the power outlet.

1.5 Insert Batteries of Remote Control

This describes the steps for inserting new batteries of the remote control or for
replacing empty batteries:
1. Open the battery compartment on the bottom side of the remote control. Re-
move the cover of the battery compartment.
2. Place the two batteries 1.5 V (type: AAA).
Ensure correct polarity!
14
 If your TV set offers both possibilities then always choose
connection via HDMI cable.
This ensures best possible audio and video quality with digi-
tal signals.
The TV set does not provide of an HDMI
connection:
 Connect TV set and receiver by using a
SCART cable.
AVANIT SHD5