Product Maintenance - Fellowes AutoMax 80M Bedienungsanleitung

BASIC SET UP
CASTER INSTALLATION
1 2
BASIC SHREDDING OPERATION
90M continuous operation: 80M continuous operation:
up to 10 minutes maximum up to 7 minutes maximum
NOTE: Shredder runs briefly NOTE: Shredder runs briefly
after each pass to clear after each pass to clear entry.
entry. Continuous operation Continuous operation beyond
beyond 10 minutes will trigger 7 minutes will trigger
40-minute cool down period. 40-minute cool down period.

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Press and hold Reverse
*Apply oil across entry
( ) for 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Remove Paper: When illuminated, set to reverse (
both levers and slowly raise up.
3 4
MANUAL FEED
1 2
Plug in and put Feed paper/card
disconnect power
straight into paper
entry and release
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
TO CLEAN THE SENSORS
1
( ) and
unplug shredder
3
Dip cotton swab in
rubbing alcohol
)
AUTO FEED
1 2
Plug in and put Open auto feed
disconnect power paper tray*
* Do not use auto feed tray to move shredder.
2
Locate Auto-start infrared sensors.
feed infrared sensor, open access panel by engaging
both levers and slowly raising up.
4
contamination from the paper sensors
3
4
Add paper
Press start ( ) to
begin shredding
3