Nave PETRO Bedienungsanleitung Seite 7

Designation
Watts
Lumen
Kelvin
Lifetime
Switching cycles
Temperature range
Connection type
USB connection
Operation
Damage to eyes
▪
Never look directly into the LED diodes of this product.
Non-compliance with these instructions can cause personal injury or damage to property.
Damage to the product
▪
Make sure that the charging current of the connected devices does not exceed a maximum of 1 A. A
higher charging current of the device to be charged can cause a defect in both devices.
▪
Note that the capacity of the device to be charged must be significantly lower than the total capacity of the
product. As a result, the charging process cannot be fully completed.
Non-compliance with this instruction can cause damage to property.
3191315_Manual_16747_V1
Abbreviation Value
W 20
lm 1200
K 6341
h 25.000
- 12.500
°C -20...+40
-
-
Load
▪
Open the dust cap.
▪
Plug the USB micro connector into the socket of the product.
▪
Connect the product to a suitable device using the charging cable. You can
charge the battery using a computer or your own power adapter with a USB port.
Turn on
▪
Press the pushbutton switch to turn on. Both light segments light up.
▪
A light segment is switched off by pressing the push button again.
▪
The light segments switch over by pressing the button again.
▪
Pressing the push button again turns off both light segments.
7 / 30
Pictogram Explanation
Maximum Power
Light intensity
Colour temperature / light colour
Hours
-
-
-
CAUTION
NOTE
V1.4/22