Led Light - Hamron 023629 Bedienungsanleitung

PUMPING – STOP
Tap the power switch button to stop the pumping manually.
When changing run mode or the preset air pressure the set run
mode and its standard air pressure flash three times, alternating
with the measured air pressure.
FIG. 6

LED LIGHT

Press the light button (h) to switch on the LED light.
Press the light button (h) to switch off the LED light.
MEASURING AIR PRESSURE
Start the product and connect the air hose to the object in which
the air pressure is to be measured. The air pressure is shown on
the pressure gauge display.
RESET OF PRESSURE GAUGE
If the air pressure shown is not 0 when the product is started
and is not connected to a tyre or ball, reset the pressure gauge
by pressing the increase/reduce buttons at the same time for 3
seconds.
NOTE:
The product is set to zero before delivery. Deviations in the
EN
33