Data Transfer; Changing The Wristband - i.safe MOBILE IS-SW1.1 Bedienungsanleitung

DATA TRANSFER

The USB interface on the IS-DCSW1.1 Desktop Charger is used for charging and data transfer.
DANGER
Improper use can result in death or severe injuries! Only use USB interface outside of explosi-
on hazardous areas.
Insert the IS-SW1.1 Smartwatch into the IS-DCSW1.1 Desktop Charger.
Connect other devices to the USB interface of the IS-DCSW1.1 Desktop Charger only by using
the i.safe PROTECTOR 2.0 USB-C Cable.

CHANGING THE WRISTBAND

DANGER
Improper use can result in death or severe injuries! Only change the wristband outside of
explosion hazardous areas.
1
1
Loosen only the screws (1) on the right side of the IS-SW1.1 Smartwatch with the
screwdriver provided.
Slide out the threaded sleeves connecting the wristband to the IS-SW1.1 Smartwatch
from right to left with the screwdriver.
Remove the wristband and insert the new wristband.
Insert the threaded sleeves from the left.
Insert the screws on the right and tighten them hand-tight with the screwdriver provided.
EN 11