Replacing The Cup Target Sensor Pc Board - NAMCO QUICK & CRASH Handbuch

7-3

Replacing the Cup Target Sensor PC Board

1. Remove the upper rear maintenance door from the Target Cabinet.
2. Remove the connectors.
3. Using needle nosed pliers, squeeze the locking tabs of the locking supports, one
at a time, to release the PC Board. Remove the Sensor PC Board.
4. Replace the board by gently pushing the board on to the locking supports.
5. Refit the connectors and upper rear maintenance door.
Target Cabinet
Sensor Bracket
Locking
Supports
Releasing the Locking Supports
PC Board
Locking Support
Stopper
Page 54
Cup Target
Cup Target
Sensor PC Board
Connectors
Tab
Needle Nosed
Pliers
Locking
Supports