Safety Instructions - HBM K3607 Bedienungsanleitung

1

Safety instructions

Approbiate use
The K3607 calibration instrument is to be used exclusively for measurement
tasks and directly related control tasks. Use for any purpose other than the
above shall be deemed to be not in accordance with the regulations.
In the interests of safety, the instrument should only be operated as described
in the Operating Manual. It is also essential to comply with the legal and safety
requirements for the application concerned during use. The same applies to
the use of accessories.
Conditions on site
S Protect the device from direct contact with water.
S Protect the device from moisture and humidity or weather conditions such
as rain, snow.
S Do not expose the device to direct sunlight.
S Please observe the permissible maximum ambient temperatures and
humidity stated in the specifications.
S The device must not be modified from the design or safety engineering
point of view except with our express agreement. Any modification shall
exclude all liability on our part for any damage resulting therefrom.
In particular, any repair or soldering work on motherboards is prohibited.
When exchanging complete modules, use only original parts from HBM.
S Install the device so that it can be disconnected from the supply voltage at
any time without difficulty.
S The device is maintenance-free.
S Before cleaning, disconnect all connections.
S Clean the housing with a soft, slightly damp (not wet!) cloth. You should
never use solvents, since these could damage the labeling.
S When cleaning, ensure that no liquid gets into the module or connections.
S
In accordance with national and local environmental protection and material
recovery and recycling regulations, old equipment that can no longer be
K3607
A0833-3.1 HBM: public
Safety instructions
3