Cleaning And Care; Declaration Of Conformity - Peaq PSB 400 Bedienungsanleitung

ENGLISH
Mounting soundbar on the wall
• Drill 4 holes (Ø 3-8 mm each according to
wall type) with correct distances. Insert wall
plugs into the drilled holes (use a hammer if
necessary) fix the brackets with the 4 screws.
Make sure that you fix the brackets the right
way round.
• Unscrew the two screws on the back and
screw in the supplied flat head screws firmly.
• Plug the power cords into the AC~ power
connections of the soundbar and subwoofer.
Plug the desired audio transmission cable into
the corresponding socket on the back of the
soundbar.
Note: If the soundbar is to be attached to a
wall and connected via an HDMI cable, you will
need an HDMI cable with an angled plug.
• Now attach the soundbar onto the brackets.
Make sure both screw heads are properly
seated in the holes.
Operation
Turn on the soundbar by pushing on / off
button at the device or at the remote control.
A blue, green or orange LED turns on.
Bluetooth
®
To play via Bluetooth
the remote control or the mode selection button
at the on-state soundbar until bt is shown in
display.
Turn on the Bluetooth
playback device and search for devices.
Connect (pair) your playback device to the
Soundbar labelled PSB 400. If the connection is
successful, an acoustic signal ("paired") sounds.
Future use of the same player will automatically
connect to the soundbar when the Bluetooth
feature is enabled on both devices. Start
playback.
If supported by your playback device you can
operate the functions play / pause
forward and back
control.
14
, press the BT button on
®
connection on the
®
using the remote
Audio input
Press the mode selection button at the on-state
soundbar or the AUX, BT, USB, OPT/COA,
HDMI1/2 or HDMI eARC button to activate
audio input. The current audio input mode is
shown in display.
Adjust the volume on the playback device or
with the volume buttons - / + on the remote
control in 32 steps.
Mute the soundbar with the mute button if
necessary.
Switch the soundbar to standby mode with
the on / off buttons
control. The selected input is retained when it is
switched on again.

Cleaning and care

• Pull the power plug from the electrical outlets
before cleaning.
• Clean the exterior with a lightly damp cloth.
• Do not use petrol, alcohol or other abrasive
cleansers to clean the exterior.
• Do not allow liquids to spill into any openings.
• Use the original packaging if it is necessary to
transport the unit.

Declaration of conformity

Hereby, Imtron GmbH declares that the radio
equipment type PSB 400 is in compliance
with Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the
following internet address:
®
http://www.peaq-online.com/nc/suche/
, skip
at the device or remote