Akai Party Box 810 Bedienungsanleitung Seite 4

TRANSPORTATION
For transportation, use the upper handle, slightly fold the appliance and use the two rear wheels.
POWER
This unit works with rechargeable
When the battery 'being phased out and the device does not turn on, plug the power cord into the
Power socket (15) on the device and plug into a wall socket to recharge.
Lamp status LED charging:
- LED indicator RED flashing: the device and 'connected to the power cord and battery and' in office.
- LED indicator fixed RED: the finished recharging, the battery and 'charge.
Caution:
- Do not connect the appliance to sockets with a voltage other than that indicated.
BASIC FUNCTIONS
POWER ON/OFF
long press the main ON/OFF power switch (01) to position ON to turn the power.
BATTERY CHARGE
- POWER switch (15) to "OFF" - "ON" to recharge the battery; the charging function and the
LED indicating charging status will start immediately.
For a longer battery life it is recommended to disconnect the mains power cable after 10 hours
max of recharging.
If the battery is empty, please turn the speaker off and recharge for at least half an hour
before using it again.
STAND-BY
You can switch the system to standby mode using the button
Press it again to Switch On the unit.
Caution:
- In standby mode the battery is NOT recharged and the device has a minimum battery consumption.
- When connecting the main power supply, long-press the power button (01) for 3 seconds, the
device will display turned
on. Which means it works normally. Short press the power button (01), the device will display
entering into stand-by mode. At the same time, the power button shows red light.
- For long periods of inactivity, it is necessary to disconnect the mains cable and recharge the
battery periodically.
M ODE SE TTING FUNCTION
To change the mode function, press more 'times the
on remote control to select: BLUETOOTH (the display BLUE), USB/SD (only if the USB socket (14)/
Micro SD (13) is connected to a memory, the display shows for a few seconds "USB" or "SD"),
AUX-IN (the display shows "LINE" or "FM").
ADJUSTING THE VOLUME
1. Turn the Main Volume control (09) to increase or decrease the overall volume of playback, or
use the buttons (05) and (11) on the remote control;
2. Press the button (07) and turn the knob (09) (treble / bass / microphone vol / microphone echo /
guitar vol) adjustment
PRE-EQUALIZER
This unit has a pre-set audio equalization system. Press the unit or the EQ button (10) on the
remote control repeatedly to select one of the 5 audio equalizations available and which best
suits the current sound reproduction.
SETTING TONE TREBLE AND BASS
Press the MENU (07) key (1) times to adjust the treble an (2) times to adjust the bass.
lithium-ion battery 7.4V, and power supply 110~240V
(01) on remote control:
key (02) on the unit or press button (04)