Lcd Display; Getting Started - Levenhuk Ermenrich LR600 Bedienungsanleitung

Levenhuk LR1500/ LR900/ LR600 Site Laser
EN
Rangefinder
Please carefully read the safety instructions and the user manual before using this product, otherwise it may result in
hazardous laser radiation and electric shock. Use the device only as specified in the user manual. Keep away from children.

LCD Display

2
5
6
11
9

Getting started

•
Open the battery compartment cover and insert 2 AAA batteries according to the correct polarity marks. Close the cover.
•
Press the POWER/MEASURE button to turn the device on or off. The rangefinder enters the distance measurement mode by default
(Fig. 1).
•
Rotate the focusing ring until the view is in focus.
•
Press and hold the MODE button to change the measurement units. Quickly press this button to choose between the modes.
There are 5 modes available: 1) distance measurement mode, 2) slope mode, 3) horizontal distance mode, 4) height distance
mode, and 5) speed mode.
Using
Distance measurement mode
In the distance measurement mode, aim the device at your intended target and press the POWER/MEASURE button. The distance
value will be displayed (Fig. 2).
Press and hold the POWER/MEASURE button for continuous measurement.
Note: The maximum measurement range is affected by weather conditions as well as the dimensions and reflectivity of the target
object.
1. Low battery indicator
2. Angle icon
1
3. Current angle value
3
4. Center of the target (bullseye)
5. Flagpole lock mode
6. Distance measurement mode
4
7. Straight line distance
8. Units of measurement
7
9. Trajectory adjustment icon
8
10. Trajectory adjustment value
11. Speed icon
10
Figure 1
Figure 2
3