Modster Mini Blizzard Pro Betriebsanleitung Seite 17

Manual
Start method 2:
Landing method 1:
Landing method 2:
Landing method 3:
www.modster.at
1. Place the drone on a flat surface. Move the two control
sticks to the position shown in the picture. After 2-3 se-
conds, the LED of the drone will flash rapidly. After 2-3
seconds, the LED will be on constantly, the calibration was
successful.
2. Press the takeoff/landing button and the drone will take off
Slowly pull the left stick back until the drone lands. After landing, hold
the stick in the rear position for another 2 seconds until the motors stop.
Press the takeoff/landing button, the drone will take off by itself and
then stop the motors.
In case of emergency, e.g. if the drone flies against an obstacle, press
the the emergency stop button. The motors will stop immediately and
the drone will to the ground. This is an emergency measure to prevent
further damage, but damage may occur in the process.
Mini Blizzard Pro
17