Technical Data; Rating Plate - Leonard LAI6031A Benutzerinformation

Problem
Automatic Heat Up does not
operate.
The heat setting changes be‐
tween two levels.
The control panel becomes
hot to the touch.
comes on.
comes on.
The outer ring is not activated.
and a number come on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes

9. TECHNICAL DATA

9.1 Rating plate

Model LAI6031A
Possible cause
The highest heat setting is set.
The zone is hot.
Power management operates.
The cookware is too large or you
put it too close to the control pan‐
el.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the
zone.
The diameter of the bottom of the
cookware is too small.
There is an error in the hob.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 492 334 00
Remedy
The highest heat setting has the
same power as the function.
Let the zone become sufficiently
cool.
Refer to "Daily use".
Put large cookware on the rear
zones, if possible.
Refer to "Daily use".
Put cookware on the zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Use cookware with a bigger bottom
diameter.
Deactivate the hob and activate it
again after 30 seconds. If
comes on again, disconnect the hob
from the electrical supply. After 30
seconds, connect the hob again. If
the problem continues, speak to an
Authorised Service Centre.
ENGLISH 15