Formula Air E-PURE ASPRA P10000 Bedienungsanleitung Seite 29

5. Usage
Error- Display
light * notification **
OFF Filter timer
has been reset.
Next filter
change in:
xxxxhxxm
OFF LOW FLOW
fan: xx%
I: xxx uA
brush: xxhxxm
v: xxxxcm/s
vref: xxxxcm/s
OFF TAKE CARE:
Reference flow
will be
measured
ONLY PRESS
AGAIN if filters
have
been replaced
OFF Filters replaced
Reference flow
will be
measured
Problem Consequence
None Filter timer has been reset
Measured System cleaning capacity might
air velocity be lower.
is low,
collectors
might be
saturated.
None ONLY IF NEW COLLECTORS HAVE
BEEN MOUNTED: press button
again.
Otherwise DO NOT UNDERTAKE
ACTION
None A new reference velocity will be
measured
User manual | Filter E-PURE ASPRA P10000
Solution /
Explanation
Filter timer has been reset
(refer to chapter 5.8 airflow
monitoring)
1. Start self-cleaning routine
2. Turn- off system and if possible
clean the surface of pre-filter
and collectors,
whether the LOW
indication disappears
for 10 min after switching on
P10000-4C)
3. Replace the filters with fresh
filters if the LOW
indication persists
Pressing the start brush button again
will instruct the system to measure
a new reference velocity. This is
needed in case COMPLETELY NEW
COLLECTORS have been mounted.
In any other situation do not press
the start brush button again as
this will interfere with the airflow
monitoring.
System will measure a new reference
velocity.
www.formula-air.com
then check
FLOW
(wait
FLOW
29