KEUCO IXMO 59501 013101 Montageanleitung Seite 4

EN
These instructions are for both the installer for
installation and the user for operation and main-
tenance of the product. After installation, please
hand them over to the user to keep.
Symbols and explanations
Attention! Warning against bodily injury or
damage to property.
Note, tip or reference
Incorrect installation
Correct installation/test of functionality
Observe installation details
Cold water
Water fl ow
Optional/accessories
Intended use
Single lever mixer tap for use in bathrooms and
WCs. Operation possible with pressure tanks and
thermally and hydraulically controlled instanta-
neous water heaters. Operation with unpressuri-
sed tanks (open water heaters) is not possible!
Operation only with potable water.
Product is only suitable for installation indoors!
Attention! Only install in frost-free places.
4
Important information, please read!
Hot water
No water fl ow
Technical specifi cations
– Flow at 3 bar pressure:
– Pressure: min. 0.5 bar/recommended 1-5 bar
– Operating pressure
– Test pressure:
– Recommended hot water inlet temperature:
– Water connection:
Avoid pressure diff erences between the cold and
hot water feeds.
Install a pressure reducer for static pressures
above 5 bar.
Installation dimensions, refer to page 2
Installation, refer to picture 1 on page 1
Flush potable water pipes thoroughly before and
after installation (observe EN 806 and 1717, as
well as DIN 1988).
Test connections for leaks with water pressure.
Operation, refer to picture 6 on page 13
Servicing, refer to picture 7 and 8 on page 13
Assemble in reverse order.
– Cartridge nut torque:
For spare parts with order numbers, refer to page 15.
For warranty and care information please refer to
the attached warranty and care instructions.
approx. 7 l/min
max. 10 bar
16 bar
max. 65°C
cold = blue marking
hot = red marking
12-13 Nm