Herunterladen Inhalt Inhalt Diese Seite drucken

Display Information - Levenhuk Ermenrich Reel GD40 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Ermenrich Reel GD40/GD60/GD80/GD100 Laser Meter
EN
Getting started
Open the battery compartment cover and insert 2 AAA batteries according to the correct polarity. Close the cover.
Using
Press (5) to turn the device on. The laser beam will switch on automatically and then off after 30 seconds. To switch it off manually, press (7).
Aim the laser beam at the target. Press (5) to take a measurement.
Press (10) for 3 seconds to turn the buzzer on/off.
Press (7) for 3 seconds to turn the device off.
Reference point
The default reference point is the bottom end of the device. Press (9) for 3 seconds to change the measurement point from the bottom to the
top of the device (Fig. A).
Units of measurement
Press (6) for 3 seconds to change the unit of measurement.
Units of measurement options
Distance
1
0.000m
2
0.00ft
3
0.0in
Mode selection
Press (10) to change the measurement mode one by one.
The setting order: Single distance measurement mode > Area measurement mode > Volume measurement mode > Calculations with 2 additional
measurements (Pythagorean theorem) > Calculations with 3 additional measurements (Pythagorean theorem) > History records.

Display information

Single distance measurement mode
Area measurement mode
Volume measurement mode
Calculations with 2 additional measurements
(Pythagorean theorem)
Figure A
Area
0.000m
2
0.00ft
2
0.0in
2
4
Volume
0.000m
3
0.00ft
3
0.0in
3
Calculations with 3 additional measurements
(Pythagorean theorem)
History records
Battery status

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis