Maintenance And Cleaning - Zelmer ZMB6000 Benutzerhandbuch

EN
replaced, pull upwards by hand. Open the bottom end of the comb lock and
push forward (fig 5-6).
Choose between four levels of matching comb to cut hair of different lengths.
The length of the cut is indicated on each limit comb as follows:
Number
1
2
3
4
HOW TO SWITCH ON/OFF THE LOCK
FUNCTION?
Long press for 3 seconds to lock the machine and then long press for 3
seconds to unlock. The display will show lock function icon when it's activated.
HOW TO TRIM BEARD
For different beard styling please refer from Fig.7 to Fig.12

MAINTENANCE AND CLEANING

After a continuous use of more than 15 minutes, the display will show washing
function icon as a reminder.
It will disappear if you turn off the machine and turn it on again.
You can rinse the blades under the tap and make sure to dry them properly.
Unplug the product when you do not intend to use it for an extended period of
time to prolong its shelf-life. Allow the device to cool down prior to storage.
Separate the tool head from the body and use the cleaning brush to remove
dust from the internal parts (Fig.13).
Apply a drop of oil on one of the edges of the blades for their maintenance, and
turn on the device for a few seconds to distribute it. This should be done when
you notice a certain amount of difficulty during the trimming operation (Fig. 14)
Level length (mm)
1 3
2 6
3 9
4 12