JBM 60039 Bedienungsanleitung Seite 7

REF. 60039
Never attempt to make any adjustments while the engine
•
is running (except when it is specifically recommended by
the manufacturer).
When maintaining, use only recommended or equivalent
•
replacement parts. Use of any other parts may create a
hazard or cause damage to the product.
Use only cold or slightly warm water. Never use water
•
above 43°C / 110°F.
Never spray near the surface to be cleaned as it may
•
damage the surface.
Never use water or any other liquid to clean or rinse the
•
product, and do not expose it to rain.
Store the tool in a dry place. Corrosive liquids, water and
•
chemicals may enter the product's or the battery electronic
components, which may result in a short circuit, increasing
the risk of fire and serious personal injury.
Remove any accumulation of dirt and debris by cleaning
•
the product with a dry cloth from time to time.
Only use the tool outdoors.
•
ASSEMBLY
Battery removal/installation
WARNING! Do not immerse the battery in water. Sudden
cooling may cause an explosion or leakage of the hot battery.
1. Remove the discharged battery (1) from the pressure washer
by pressing the battery release button (2) and sliding the battery
backwards out of the tool (3).
2. Slide the fully charged battery into the corresponding keys of
the brushless electric pressure washer (3).
NOTE: Make sure the slots on the battery are fully engaged with
the slots of the brushless electric pressure washer assembly.
The battery release button will snap into place when the battery
is fully installed.
WAND INSTALLATION
1. Insert the end of the wand into the front opening of the
cleaner.
2. Make sure that both the large and small tabs, located on the
end of the wand, are aligned with the large and small notches
located on the inside of the front opening of the pressure
washer.
3. Turn clockwise to lock the wand into the pressure washer.
4. To remove the wand from the pressure washer, press the
wand and twist it counterclockwise. Then pull it out.
SWIVEL NOZZLE INSTALLATION
1. Push back the quick coupler.
2. Insert the swivel into the coupler.
3. Release the quick coupler to lock the swivel nozzle.
4. Before using the tool, pull the nozzle to make sure it is
correctly locked into the quick nozzle.
ATTACHMENT OF WATER INLET HOSE
1. Pull the hose's quick coupler (1) backwards.
2. Insert the hose into the pressure washer.
3. Release the quick coupler to lock the hose.
4. Before using the tool, pull the hose to make sure it is locked
in place.
5. To remove the hose from the pressure washer, pull the quick
coupler (1).
6. Put the other end of the tube
inside a bucket filled with water.
· 7 ·
1
1