elysia xpressor neo Bedienungsanleitung Seite 3

Compatibility
The xpressor neo is a module to be installed into an API 500 series com-
patible rack frame (not included if not elysia qube). It needs the power
supply and the audio connectors provided by this frame and does not
function stand alone.
The current consumption is 125 milliamperes at +/- 16 volts DC. This is
actually more than many other 500 series modules consume as a result
of the discrete class-A design of the xpressor's audio path.
Most API 500 compatible racks will meet this requirement without prob-
lems, but there might be a limitation of how many units can be installed
in a single rack. In case of doubt please check with the manufacturer of
your specific rack.
Installation
Just follow these easy steps to install the xpressor neo module:
1. Switch your API 500 series compatible rack off and disconnect the
power cable from mains.
2. Insert the module into two free slots of your rack. Make sure both PCB
connectors match with the rack connectors.
3. Gently push the module in place - do not use any extensive force here!
4. Tighten the front panel with four screws provided by your rack manu-
facturer.
5. Connect your XLR audio cables (see page 6 for more info) and apply
power to your rack or elysia qube.
And this is already it.
Have lots of fun with your xpressor neo!
3