EFOY CC1 Bedienungsanleitung Seite 14

4. Operation 4. Operation 4. Operation 4. Operation
Replace the plate in the housing and pass the two
attached wires through the opening to the exterior.
Tighten the four screws on the housing and snap the
frame onto the cluster controller.
Now connect your device(s) to the cluster controller as
described in Chapters 4.1 and 4.2.
In order to use the functions of the "Remote On" In order to use the functions of the "Remote On"
In order to use the functions of the "Remote On" In order to use the functions of the "Remote On"
contacts, a device must be connected to the first port contacts, a device must be connected to the first port contacts, a device must be connected to the first port contacts, a device must be connected to the first port
(on the left side, marked with "EFOY" and "1"). (on the left side, marked with "EFOY" and "1"). (on the left side, marked with "EFOY" and "1"). (on the left side, marked with "EFOY" and "1").
If a voltage between 3 V and 40 V is applied to the
"Remote On" contacts, the device that is connected to
the first port on the cluster controller will
automatically switch to charge mode. An "R" (for
"Remote") will appear on the first line of the display on
the right. If additional devices have been connected to
the cluster controller, they will come on line after a
three-minute delay.
The thresholds set in the device are not observed in
this case. A safety threshold (dependent on voltage and
current) remains active in order to prevent
overcharging of the battery.
Make sure that the "Remote On" signal disappears Make sure tha t the "Remote On" signal disappears
Make sure tha Make sure tha t the "Remote On" signal disappears t the "Remote On" signal disappears
after you have finished charging. If the signal remains after you have finished charging. If the signal remains after you have finished charging. If the signal remains after you have finished charging. If the signal remains
on for a long time when the battery is fully charged, the on for a long time when the battery is fully charged, the on for a long time when the battery is fully charged, the on for a long time when the battery is fully charged, the
device will restart after just a slight dip in battery device will restart after just a slight dip in battery device will restart after just a slight dip in battery device will restart after just a slight dip in battery
voltage. This could result in increased wear and te voltage. This could result in increased wear and tear of
voltage. This could result in increased wear and te voltage. This could result in increased wear and te
the device(s). the device(s). the device(s). the device(s).
14
ar of
ar of ar of