Vaporesso GEN 200 Bedienungsanleitung Seite 5

FIGURE
Figure 1: Replace the coil
Figure 2: Fill e-liquid
OPEN
Figure 3 User Interface
System Lock
Smart VW
Resistance
Puff Counter
Output Mode
USER INSTRUCATIONS
1. Install the Tank
Install the tank to the battery by screwing the 510 thread. Make sure they are firmly
connected.
2. Replace the Coil
- Unscrew the thread base from the tank;
- Pull out the used coil from the tank;
- Install a new coil to the tank;
- Reattach the thread base into place.
* Refer to the figure 1.
3. Fill E-liquid
- Push the top cap according to the arrow direction;
- fill e-liquid through the hole, then lock the top cap in place after filling is finished.
- Please wait 5 minutes for the e-liquid to soak into the coil completely.
* Refer to the figure 2.
4. Adjust the Airflow
To adjust the airflow volume, please rotate the air-inlet ring on the bottom of the tank.
5. Power On/Off the Device
Power on/off: press the power button 5 times in 2s.
6. Power Adjustment
GEN 200 & 80 S Kit is using the powerful GTi coil platform, and the suggested power need to
be noticed before start vaping.
GTi MESH Coils
Suggested Power
7. Start Vaping
Press the power button to enjoy extraordinary vaping experience.
8. Charge the Battery
After connecting the Type-C cable to the battery, the battery indicator and remaining
charging time will be showed on the screen.
CLOSE
GTi 0.2Ω MESH
60-75W
Wattage
Output Voltage
Battery Level
Vaping Time
GTi 0.4Ω MESH
50-60W
ENGLISH 2