Ac Connection; Safety Instructions For The Ac Connection; Cabling Requirements - Ingeteam INGEREV RAPID 60 Handbuch Für Montage Und Betrieb

Ingeteam

8. AC connection

This chapter explains the requirements and process for connecting the AC wiring to the unit. The circuits for DC
and AC (if available) charging are derived internally from this connection.
Read carefully before starting the connection process.
INFO
Consult section "Important safety instructions"

8.1. Safety instructions for the AC connection

DANGER
Make sure there is no voltage present on the unit before starting the AC connection.
Do not switch on the power to the unit until you have successfully made the rest of the connections and it is
closed.
Use the Personal Protective Equipment specified in the section
During the connection, ensure the correct connection of the cables to the corresponding busbars.
It is essential to correctly replace the IP2X protections once the AC connections have been made.
CAUTION
Ingeteam accepts no liability for any damages caused by an incorrect connection.

8.2. Cabling requirements

To guarantee the safety of persons, for the unit to function correctly and comply with the applicable standards, the
unit must be connected to the ground of the installation.
76
and the following instructions before working on the unit
Fig. 5 Image of the IP2X protection of the connection
"Personal Protective Equipment (PPE)"
ACA2011IQM01_ - Installation and Operation Manual
AC connection