Toro Revolution 60 V Bedienungsanleitung Seite 9

Troubleshooting
Perform only the steps described in these instructions. All further inspection, maintenance, and repair work
must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the
problem yourself.
Problem
The tool does not run or does not run
continuously when the tether is installed.
Possible Cause
1. The battery connector is not fully
installed into the tool.
2. The backpack connector is not fully
installed into the backpack.
3. The battery pack(s) are not charged.
4. There is moisture on the leads of the
battery pack(s)
5. There is moisture on the leads of
the backpack connector, or battery
connector.
6. The backpack tether is damaged.
7. The battery pack(s) are damaged.
8. The battery pack(s) are over or under
the appropriate temperature range.
9. There is another electrical problem with
the tool, backpack, battery or tether.
7
Corrective Action
1. Remove and then replace the battery
connector into the tool making sure
that it is fully installed and latched.
2. Remove and then replace the
backpack connector into the backpack
making sure that it is fully installed and
latched.
3. Remove the battery pack(s) from the
tool and charge them.
4. Remove the battery pack(s) and allow
them to dry or wipe them dry.
5. Remove both the backpack connector
and the battery connector and allow
them to dry or wipe them dry.
6. Replace the backpack tether or contact
an Authorized Service Dealer.
7. Replace the battery pack(s) or contact
an Authorized Service Dealer.
8. Move the battery pack(s) to a place
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
9. Contact an Authorized Service Dealer.