Optika Italy H-Serie Bedienungsanleitung Seite 12

4. Finally as shown below, 2 HDMI cameras are connected to the router with LAN cable and 2 HDMI cameras are connect-
ed to the same router with WLAN STA mode (the number of the cameras, the connection mode (LAN or WLAN STA)
connected to the router are determined by the router performance).
5. Make sure that your PC is connected to the LAN or WLAN of the router.
6. Start ProView / LiteView software and check the configuration. Normally, active cameras are automatically recognized.
The live image of each camera is displayed.
7. For the display, the Camera List tool window is used in the ProView/LiteView software.
Fig. 7 - PROVIEW and C-HUB4K Cameras connected in LAN port/WLAN STA mode
• Note on data security
The data transfer of the HDMI 4K camera in LAN or WLAN is not encrypted. Anyone who is connected to the network and
has installed the Optika software, can see the live image of all active cameras.
Operate the camera with the ProView software, if you want to make sure that nobody in the network can see the camera's
live image.
• About the routers/switches
It is suggested that routers/switches supporting 802.11ac 5G segment should be selected to achieve better wireless con-
nection experience.
Page 12