Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Power Button:
When the unit is turned on for the first time, all LED lights will be on for about 1 second and will then
enter the standby state.
Switch/Mode button:
In the standby state, touch this button for the first time and the appliance will turn on and run in
natural wind mode, with the letters "FA" displayed on screen. Touch this button for the second time
and you will switch the appliance into warm wind mode. The screen will display the letters "LO" .
Touch it for the third time and you switch the appliance into hot wind mode, and the screen will
display the letter "H1". Touch the button again and you will make the appliance switch back to
natural wind mode.
The buzzer will sound once you touch the switch. After no operation for 5 seconds, the screen will
display the current temperature. In the condition of working, touch the switch for 3 seconds and the
appliance will enter standby state.
Timer Button:
In the condition of working touching this button can set the timer among the circulation of 1H-2H-
4H-8H-continuous.When setting the timer the corresponding indicator will light up except the
continuous working mode. The buzzer will ring every time when you touch the timer button. The
button can also work as a network button. Long touch the button for about 5 seconds to set or reset
the network.
Temperature button:
Temperature setting range: 15°C-35°C. In the condition of working, touch the button for the first
time and the temperature will set to 35°C. Touch the button again will set the temperature to 15°C,
after that, touch this button once, and the temperature will rise by 1°C each time, and the buzzer will
sound once. After no operation for 5 seconds, the screen will display the current temperature. When
the detected temperature is lower than 0°C or higher than 50°C, the screen will show "--".
(Notice: If the temperature has not been set, the appliance does not perform energy-saving mode
and does not carry out temperature control. It only run in the current working mode.)
The working status is shown in the following table:
TABEL XXX TABEL XXX TABEL XXX
Long touch the temperature button for 5 seconds and you will be able to connect it to the Wifi.
When the WiFi connected in the SmartConfig mode the WiFi indicator will flashes quickly twice per
second. When the WiFi connected in the app mode the WiFi indicator blinks slowly once per 2
second.
Notice:
Turn off the appliance though the App the Wifi will be disconnected after 1 second and the appliance
cannot be operated by the app anymore. If the app operation is needed, tunr on the appliance
manually and long touch the swing button for 5seconds, then the appliance will match the phone
automatically.
Wide angle heating:
Werbung
Inhaltsverzeichnis
