Kingston Technology IronKey Locker Plus 50 Bedienungsanleitung Seite 19

 →
USB Cloud Initialization (macOS Environment)
• Once the device has been initialized, the USB-to-Cloud
application will appear as seen in Figure 5.6 to the right.
Please make sure you have a working Internet connection
before you continue.
• To proceed with the installation, click the 'Accept' button in
the bottom right-hand corner of the clevX window.
(Note: On macOS 10.15.x + will be prompted to allow access
to files on a removable volume. Select OK.) (See Figure 5.7)
• To decline the installation, click the 'Decline' button in the
bottom left-hand corner of the clevX window.
(Note: If you click the 'Decline' button, it will cancel the USB-
to-Cloud installation. In doing so, a special file named
'DontInstallUSBtoCloud' is created on the data partition. The
presence of this file will prevent the application from
prompting you for the installation in the future.)
• Once the installation has completed, you will see an
application box with a list of options to choose from (for
syncing your LP50 data.) (Figure 5.8)
• Select the cloud option you wish to use as your backup
application and provide the necessary credentials required for
authentication.
(Note: If you currently do not have an account set up with any
of the cloud options listed, you may create one at this time,
using your favorite Internet browser, and then completing
this option afterwards.)
•
Once you've chosen a cloud option and authenticated to the
corresponding service, the USB-to-Cloud program will
perform an initial comparison of the data partition against
what is stored in the Cloud. As long as the USB-to-Cloud
service is running in Task Manager, content written to the
data partition will automatically back up (sync) to the Cloud.
Figure 5.6 – USBtoCloud macOS EULA
Figure 5.7- macOS access
Figure 5.8- Cloud Selection
18