IMER H110VF Handbuch Für Bedienung, Wartung Und Ersatzteile Seite 30

TRANSPORT AND MAINTENANCE
PROBLEM CAUSES
The machine is not
plugged into the electrical
Power cable broken.
does not remain ON
when pressed. No voltage reaching sup-
Motor does not start.
Blade does not cut. Blade worn.
The blade does not
Slack belt tensioning.
stop within 10 seconds.
11. Routine Maintenance
Before starting work, check that:
sive slack.
- the adjustable parts (cutting height, workpiece guide position,
- The wedge and blade are aligned.
- The distance between the wedge and the blade is 3 to 8 mm
At the end of each work shift, remove the chips from the com-
Regular maintenance of the machine helps to reduce the noise
levels to which the operator is exposed.
12. Major Servicing
Before starting work, check that The saw must be disconnected
The following more thorough checks should be made peri-
- that the machine does not show signs of slight damage which
- that the cutting disk stopping time is < 10 seconds, if not, do
not use the machine and make sure the belt is tensioned cor-
IMER INTERNATIONAL S.p.A.
H110VF - H110VR
13. Transport
CORRECTIVE ACTION
Change cable.
Check line.
If lifting equipment is used, the sawing machine must be slung
Change switch.
Change fuse.
corners of the machine.
Replace with new blade.
Tension the belts cor-
14. Wheels and handle kit
facilitate moving the machine.
-
-
-
FIG.10-A
-
34
A1
Fig. 11
GB
-
-
B1