How To Scan - VistaQuest HS-550 Bedienungsanleitung

5.5 How to scan

Note: To scan, make sure your scanner is not connected to the computer.
1. Turn on the scanner by pressing the [POWER/SCAN] button for 2 seconds.
2. Hold the document firmly with one hand on a flat surface.
3. Place the scanner on the edge of the paper approximately 5/8 to 3/4 of an
inch onto the page to ensure the whole document can be scanner. Make sure
to keep the scanning area in between the scanning width indicators marked
on the side of the scanner.
3. Hold the scanner flat against the material and then press the [SCAN] button
once.
5. Slide the scanner slowly, keeping your hand stable to get the best quality
picture.
6. Press the [SCAN] button again to stop scanning.