VistaQuest HS-550 Bedienungsanleitung Seite 16

2. Press [MENU] button to enter MENU Setup
3. Press UP/DOWN buttons to select FORMAT
4. Press [OK] to enter FORMAT mode
5. Press UP/DOWN buttons to select FORMAT options
a.
b.
6. Press [OK] to confirm selection and return to Menu Setup screen
5.3.7 DELETE FILE setting
1. Press [MENU] button to enter MENU Setup
2. Press UP/DOWN buttons to select DELETE FILE
3. Press [OK] to enter DELETE FILE mode
4. Press UP/DOWN buttons to select DELETE FILE options:
a.
b.
5. Press [OK] to confirm selection and return to Menu Setup screen
5.3.8 Software VERSION
To view scanner's version number:
1. Press [MENU] button to enter MENU Setup
2. Press UP/DOWN buttons to select VERSION
3. Press [OK] to confirm selection to display version number
4. Press [MENU] to exit and return to Menu Setup screen
5.4 How to calibrate the scanner
Note: Perform calibration only when white balance needs adjustment
1. With the dry cleaning cloth provided, clean the scanning lens located on the
bottom of the scanner.
2. Turn on the scanner by pressing the [POWER] button. Place the scanner on
the white area of the White Balance Calibration paper provided.
3. Press and hold the UP button. While holding the UP button, press the [POWER]
button and then release both buttons to enter into auto-calibration mode. SD
symbol
4. Do not move the scanner. Wait until the "RED" LED turns off. "GREEN" LED will
stay on.
5. With only the "GREEN" LED light on, start scanning the white paper by sliding
the scanner across the paper until the "GREEN" LED light turns off. (Slide the
scanner backwards if necessary).
6. Press and hold the [POWER] button to power off the scanner. Calibration is
complete.
YES: To FORMAT and erase contents in microSD card
NO: To exit FORMAT mode and return to previous Menu setup
screen
DELETE ONE: To delete last image scanned
DELETE ALL: To delete all files on microSD card
will flash and then stop. "GREEN" and "RED" LED light will turn on.